Available from EU1 to EU4 as per DIN 24185 part II or G1 to G4 as per EN779

NonWoven Polyester Media with Aluminium expanded mesh reinforcement on both sides of the media

Pleated media for enhanced air handling capacity & lesser pressure drop

Most suitable as a prefilter for LAF cabinets, clean room return air filters and air handling unit prefilters

Synthetic adhesives to bond media to frame

Cleanable with compressed air

Water Washable Type

Available with an efficiency of 90% down to 20 microns to 10 microns as per IS 7613 test dust No.3

Several layers of High density poly ethylene(HDPE) mesh stitched together with an aluminium expanded metal layer reinforcement in between the  High density poly ethylene(HDPE) mesh layers

Pleated media for enhanced air handling capacity & lesser pressure drop

Suitable as a pre-filter for comfort air handling units

Water insolvable sealants for bonding media with frame

Fully water washable

Available at 90% down to 20 microns

A combination of flat & corrugated layers of metallic mesh

Available with GI / Brass / Aluminium / SS meshes

Fineness of the mesh increases towards the air leaving side.

Suitable as a paint booth exhaust and kitchen hood exhaust filter

To be used in series with a louver filter attached to it to obtain good life of the filter.

Impec make Pre filters are available in the following standard sizes

Non-standard sizes can also be manufactured as per specific customer   requirements

The filter frame can be fabricated with / without flange as per customer   requirements

Protective screen or perforated sheet can be provided on specific     requests

Available in casing thickness from 0.5 mm to 1.5 mm in variants of Mild steel/Galvanised steel/Aluminium/Stainless steel with a surface finish of enamel painted or powder coated finish or without any surface finish also